Glacier bay HD67513W-6004 Guía De Instalación Y Cuidado página 5

Installation (continued)
3
Installing the drain body
□
Apply silicone sealant (not included) under the
drain flange (E) and place the drain flange (E)
into the drain hole of the sink.
□
From underneath the sink, screw the drain
body (H) onto the drain flange (E). Ensure that
the opening (1) for the ball rod on the drain
body (H) faces towards the rear of the sink.
□
Tighten the rubber washer (F) and lock nut (G)
on the drain body (H). Hand-tighten only.
1
F
G
H
E
1
4
Installing the stopper and
horizontal rod
□
Before installation, unscrew the protective cap (1)
from the horizontal rod (J).
□
Insert the stopper (D) into the drain hole in the sink.
□
Insert the horizontal rod (J) into the drain body (H)
and through the hole of the stopper (D) until you
hear a click. See insert 2. You can press the two
sides of the joint (I) to remove the horizontal rod (J).
NOTE: For easier removal and cleaning, rotate the stopper
(D) 90 degrees so that the horizontal rod (J) does not go
through the hole in the stopper (D). See insert 3.
1
Insert 3
H
5
Please contact 1-855-HD-GLACIER for further assistance.
D
2
J
H
Insert 2
I
I
HOMEDEPOT.COM/GLACIERBAY
J