Publicidad
Idiomas disponibles
Idiomas disponibles
Temperature Setting
• Unlock the control panel by pressing the
Once the control panel is unlocked, an audible beep will be heard and the
indicator light will go out.
• Under normal conditions, the temperature display indicates the current temperature
of the corresponding zone. When adjusting the temperature, the temperature display
will flash to indicate that the temperature is being adjusted.
• The temperature in the left & right zones can be set independently by pressing the
warmer or
colder pads that correspond to the desired zone. The temperature
range of both zones can be set between 39
• When the
warmer or
increase or decrease in increments of one degree. If the
pad is pressed and held for 2 seconds, the temperature displayed will increase or
decrease at a speed of one degree per half second.
• Once you have adjusted the left and/or right zone to the desired temperature,
release the temperature pad. At this time the temperature displayed will flash for
approximately 3 seconds to confirm the selected temperature. Once the display stops
flashing the temperature display will indicate the current temperature of that zone.
Note: The temperature display can be changed between Celsius and Fahrenheit by
simultaneously pressing and holding both
approximately 3 seconds. This unit cannot be in
operation.
Interior Light
• To turn on / off the interior light, press the
lock mode to perform this operation.
Note: The light will turn on / off after the touch pad is released.
lock pad for approximately 3 seconds.
o
F to 64
colder pad is pressed, the temperature displayed will
warmer and
light pad. The unit cannot be in the
EN - 10
o
o
o
F (4
C to 18
C) +/- 5
warmer or
colder pads for
lock mode to perform this
10
lock
o
F.
colder
Publicidad
