HAIRCUT PROFESSIONAL TH55 Manual De Utilización página 23

EN
PROFESSIONAL CORDLESS TRIMMER
3.2. Operation
When first used, lubricate the blades by applying a drop of oil to the points
shown (Fig. 5).
3.2.1. Switching on/off
 Switch the trimmer on by pressing the On/Off button (Fig. 1-B). The button
lights up.
 To stop the trimmer, press the On/Off button again (Fig. 1-B). The button goes
out.
 When the trimmer is not in use, it is advisable to clip the cutter cover (Fig. 1-K)
onto the blades.
3.2.2. Use with or without power lead
 With a new, fully charged battery, the trimmer can be used without the power
lead for about 4 hours.
 Before the end of the autonomy period, the On/Off button flashes (Fig. 1-B).
Charge the trimmer battery, refer to § 3.1.
 The trimmer can be used with the electrical lead. For this, connect the cable to
the trimmer (Fig. 3a) and connect the power pack (Fig. 1-H) to a mains power
socket.
3.3. Using the comb attachments
 The trimmer
(Fig. 1 refs. D-F).
 Place the comb attachment on the blades and clip in at the rear. When the
comb attachment is correctly fixed, it is immobilized.
3.4. Replacing blades
 Switch the trimmer off and unplug the unit from the mains power supply.
 Take the screws out of the blades (Fig. 4) and remove the upper and lower
cutters.
 Replace the guide on the lower cutter and reinsert the blades.
 Tighten the two screws (Fig. 4).
must be switched off. Select
23
a comb attachment