Publicidad
Idiomas disponibles
Idiomas disponibles
C. Screw down the oil-discharging screw on the lid of the spark plug. Pull the
starting hold for three or four times, and discharge the gasoline from the
oil-spouting pump.
D. Turn the switch of the engine to the "CLOSE" position. Then screw the
oil-discharging screw tightly.
E. Re-install the cap of the spark plug on the spark plug.
3. Discharge the machine oil.
4. Dismantle the spark plug, and pour a big spoon of clean machine oil into the
engine. Make the engine rotate for several circles to make the oil evenly
distribute. Install the spark plug again.
5. Pull the starting hold (Fig. 2) slowly until you feel the resistance. At this time,
the piston reaches the compressed stroke, and both the entering and the
discharging valve are closed. To store the generator under such condition will
help to prevent the inside of the machine rusting.
G2000i Inverter Generator
28
Publicidad
