GE AHC10 Manual Del Propietario Y Instrucciones De Instalación página 5

Controls
Features and appearance will vary.
Lights beside the touch pads on the air conditioner control panel
indicate the selected settings.
1 2
Air Conditioner Controls
1. Power Pad
Turns air conditioner on and off. When turned on, the
display will show the Set temperature.
2. Display
Shows the Set temperature or time remaining on the
Delay timer. Shows the Set temperature while setting
the temperature in Cool or Eco modes.
be set in Cool and Eco mode.
4. Mode Pad
Eco mode.
5. Fan Speed Pad
In Cool or Eco
High, Med or Low on the unit.
In Fan Only
Med, or Low on the unit.
6. Delay Pad (set by remote control only)
Delay ON—When the air conditioner is off, it can be set
to automatically come on in 1 to 24 hours at its previous
mode and fan settings.
Delay OFF—When the air conditioner is on, it can be
set to automatically turn off in 1 to 24 hours.
How to set:
Press the Delay pad on the remote control. Each touch
of the
control will set the timer in 1-hour intervals.
To review the remaining time on the Delay timer, press
the Delay
pads on the remote control to set a new
time if desired.
To cancel the timer, press
remote control until the set time is zero.
49-5000097 Rev. 5
3 4
Mode Cool Fan Eco
Speed Auto Med High
5
Fan Only, Cool, or
High,
pads on the remote
Increase
pad on the
8 7
Filter Sleep
WiFi
Solid light indicates WiFi
9
connected
Blinking light indicates
connecting
See Appliance Communication
section in this manual
7. Sleep Pad (set by air conditioner controls only)
The SLEEP mode sets the unit to gradually change
settings over an 8 hour period to allow for some
increased energy efficiency during sleep hours.
The SLEEP mode is available only in COOL and FAN
only settings.
Press the SLEEP mode pad and its light will illuminate.
The fan indicator will stay at the same setting but the air
conditioner will automatically change the FAN speed to
low in either COOL or FAN only mode.
In FAN only mode, the fan will stay in the LOW speed
setting for 8 hours. After 8 hours, the air conditioner
will resume the settings that were in place before the
SLEEP mode pad was pressed.
In COOL mode, the fan will stay in the LOW speed
Auto,
setting for 8 hours from the time the SLEEP mode pad
was pressed. The air conditioner will also raise the set
point 2°F in 30 minutes and 2°F more in another 30
minutes where it will remain for the next 7 hours. After
8 hours, the air conditioner will resume the settings
that were in place before the SLEEP mode pad was
pressed.
While the unit is in SLEEP mode, pressing any pad will
return it to the settings that were in place before the
SLEEP mode pad was pressed.
8. Filter Reset Pad
This feature automatically notifies you that the air filter
must be cleaned. The indicator light will come on after
250 hours of operation. Clean the air filter (refer to page
6), place it back in the front panel, and press the Filter
Reset pad. The light will go off.
9. WiFi Connect Pad
Enables connection of the air conditioner to the home
WiFi. Download App for details at:
1
Power
5
Speed
3
4
Mode
6
Eco Delay
Remote Control
.
5