Publicidad
Idiomas disponibles
Idiomas disponibles
Reset to zero
The hand dynamometer sensor comes pre-calibrated;
however, after use, you may find that the sensor is
slightly off or you may want to run an experiment that
requires you to zero it with a constant applied force.
To zero the sensor:
1. Connect the NUL-237 hand dynamometer sensor to
a computer/tablet/smart device following one of the
guides below.
2. Open the NeuLog application.
3. When your sensor has been detected, click on the
hand dynamometer sensor module box (on the left
side of your screen).
4. Remove all applied force from the sensor and click
reset to zero your hand dynamometer sensor.
5. Your hand dynamometer sensor is now reset.
Note: You can zero the scale with a constant force being
applied to it to set that value as your new "zero".
V2018.01
19
Home
English
Publicidad
