Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
3
Installing the drain body
Apply silicone caulk (not included) under the
drain flange (D) and place the drain flange (D)
over the drain hole in the sink.
From underneath the sink, screw the drain
body (G) onto the drain flange (D). Ensure that
the opening (1) for the ball rod on the drain
body (G) faces towards the rear of the sink.
Tighten the rubber washer (E) and lock nut (F)
on the drain body (G).
E
D
F
1
G
4
Installing the plunger and ball
rod
Insert the plunger (H) into the drain hole in the
sink.
Remove the lift rod strap (K) and spring clip (L)
from the ball rod (M).
Remove the ball nut (N). Insert the ball rod (M)
into the drain body (G) and through the hole of
the plunger (H).
For easier removal and cleaning, rotate the
plunger (H) 90 degrees so that the ball rod (M)
does not go through the hole in the plunger (H).
Push the bushing (O) and ball nut (N) against
the hole in the drain body (G) and tighten the
ball nut (N) onto the threaded end.
H
1
1
5
Please contact 1-855-434-5224 for further assistance.
K
1
N
2
O
1
G
3
HOMEDEPOT.com/GLACIERBAY
L
M
Publicidad
