Publicidad
Idiomas disponibles
Idiomas disponibles
21
Home
Technical background
The philosophy behind NeuLog's plug and play
technology is based on each sensor's ability to store its
own data due to an internal flash memory chip and
micro-controller in each plastic NeuLog body. This
technology allows the sensor to collect and then store
the digital data in the correct scientific units (for
o
o
example:
C,
F, Lux, %, ppm).
The sensor is pre-calibrated at the factory. The built-in
software in the logger can be upgraded for free at any
time using the provided firmware update.
The probe shaft is installed in a bearing and has a
magnet at its end. A digital sensor based on The Hall
Effect sensor, an analog circuit and a very sophisticated
digital processor are located near the rotating magnet.
The analog and digital circuits analyze the rotating
magnetic field and calculate the angle, rotation speed,
acceleration and revolutions, transferring this data to
the sensor's controller, upon its request.
V2018.01
English
Publicidad
