Publicidad
Idiomas disponibles
Idiomas disponibles
Setting up the soil moisture probe
The NeuLog soil moisture sensor requires only a minimal
setup prior to each use. Be sure to properly configure
your NeuLog sensor using one of the following guides
(computer/smart device/viewer) prior to data collection.
1. Remove the soil moisture probe's cap which is wired
directly into the sensor's body.
2. Immerse the ceramic cone in tap water. It is
recommended to leave it in the water for 15 minutes.
3. Fill the probe's ceramic cone with tap water.
Note: More water will last longer and provide more
accurate results though be sure to allow some room
for air at the top of the column.
4. Replace the plastic cap and firmly press down to
form a strong seal.
5. Gently press the probe (ceramic cone side first)
vertically into the soil that you want to test.
6. Ensure that the entire ceramic cone has been
pressed into the soil.
7. Begin collecting data.
V2018.01
19
Home
English
Publicidad
