Publicidad
Idiomas disponibles
Idiomas disponibles
TO USE
1.
Mix material according the
manufacturer's instructions. Mixture
should be smooth and easily pourable.
Lumps or foreign particles should be
removed by straining through a
suitable paint filter.
2.
Fill the material cup (e) 3/4 full.
3.
Attach material cup (e) to the gun
securely.
4.
Attach air supply line to 1/4 NPT air
inlet (c).
5.
Adjust spray pattern.
a.
The position of the air cap horns
(g) will determine the spray
pattern. Loosen air cap (h) and
rotate horns to achieve desired
pattern. Tighten air cap.
6.
Turn fluid control knob (b) clockwise
until it stops, do not force. This will
shut off the fluid flow. NOTE: The fluid
or density of "fan spray" is controlled
by fluid control knob (b).
7.
Adjust air pressure to 50 psi at air
compressor.
8.
Turn air valve control knob (a) counterclockwise until it stops. NOTE: Air
flow is controlled by air valve control knob (a).
the gun is triggered and could leave the gun with force.
NOTE: Care should be exercised when handling spray gun to avoid damage to
the orifice of the air cap and tip of fluid nozzle. Damage to these parts results in
irregular spray patterns.
9.
Depress spray gun trigger (d) and gradually turn the fluid control knob (b)
counterclockwise until desired fluid flow is reached. Trigger gun quickly, one
second on-off to test pattern.
injury.
NOTE: If gun sprays too fast, decrease the air and fluid pressure. If too slow,
increase the pressure. Turn fluid control knob (b) counterclockwise to increase,
or clockwise to decrease, the fluid flow. Turn air valve control knob (a) counter-
clockwise to increase, or clockwise to decrease, the air flow.
DO NOT exceed 60 psi.
DO NOT turn fluid control knob out until the first
thread is past the gun body. It is under pressure when
NEVER point spray gun at self or any other person.
Accidental discharge of material may result in serious
5- ENG
g
h
a
Horizontal position
d
c
b
e
Vertical position
D28267
Publicidad
