Publicidad
TAILWHEEL INSTALLATION 3 POINT LIFT and SEMI
1. Place the height adjusting collar on the tailwheel beam.
2. Attach the height adjusting bracket to the base frame of the machine. Use two each 1/2" x 3-1/4" cap-
screws, 1/2" locknuts per bracket.
3. Place the tailwheel beam between the mounting lugs on the base frame and secure with 1/2" x 4-1/2"
capscrews and 1/2" locknuts.
4. With the tailwheel beam in the slot of the adjusting bracket, slide the adjusting collar to the bracket and
install with two 1/2" x 1-1/4" capscrews and1/2" locknuts.
5. Place the tailwheel through the pivot tube of the tailwheel beam and secure with spiral pin.
6
Apply Grease to pivot tube.
Height Adjusting
Tailwheel Beam
Spiral Pin
Tailwheel Assembly
2208 SERIES 05/21
© 2021 Alamo Group Inc.
ASSEMBLY
MOUNT MODELS
DUAL TAILWHEEL BEAM ASSEMBLY
Capscrew 1/2" x4-1/2"
Locknut 1/2"
Height Adjusting
Bracket
Collar
Capscrew 1/2" x1-1/2"
Locknut 1/2"
Assembly Section 3-6
Capscrew 1/2" x3-1/4"
Locknut 1/2"
Mounting Lugs
Publicidad
