Publicidad
Idiomas disponibles
Idiomas disponibles
21
Home
Technical background
The philosophy behind NeuLog's plug and play
technology is based on each sensor's ability to store its
own data due to an internal flash memory chip and
micro-controller in each plastic NeuLog body. This
technology allows the sensor to collect and then store
the digital data in the correct scientific units (for
o
o
example:
C,
F, Lux, %, ppm).
The sensor is pre-calibrated at the factory. The built-in
software in the logger can be upgraded for free at any
time using the provided firmware update.
The dew point sensor relies on two different sensors to
accurately determine the dew point of an environment: a
temperature and a humidity sensor.
The internal humidity sensor utilizes a dielectric polymer
to absorb water molecules. As more water molecules
enter, the capacitance changes proportionally to the
relative humidity value. Using this technique, an
accurate relative humidity value is calculated.
The internal temperature sensor uses a thermistor which
changes its resistance according to temperature
change. Resistance is measured and converted into
temperature.
Dew point is calculated using both the environmental
temperature and relative humidity values.
V2018.01
English
Publicidad
