Systembuild Evolution 2963315COM Instrucciones De Montaje página 17

STEP 9
Position back panel as shown.
Flush bottom edge with bottom edge of bottom shelf (D).
Assure your unit is square. Distance from corner to corner must be equal as shown.
Attached the back panel as shown nailing straight into the raw edges.
Make sure the notch in the back panel is positioned over the safety bracket (11).
systembuild.com
7
IMPORTANT! THE BACK PANEL IS A STRUCTURAL PART OF THIS UNIT
AND MUST BE INSTALLED PROPERLY.
(x26)
17
7
You
Tube