Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install the
product.
WARNING
•
Save these warnings and instructions for reference. Read all instructions before use.
Failure to follow warnings and instructions may result in injury or property damage.
•
•
California Prop. 65 Warning: This product can expose you to the chemicals including Lead
and Lead Compounds, which are know to the state of California to cause cancer and birth
defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
•
Excessive weight or pressure on any of the fountain sections may cause it to fall. Keep pets,
children, or anyone from sitting, leaning, or climbing on any of the fountain components.
While fountain is designed to operate as splash free as possible, some water splashing out of
•
the fountain is inevitable. Place the fountain in a location where any splashing will not cause
damage.
The National Electric Code requires that a ground fault circuit interrupter (GFCI) be used in the
•
branch circuit supplying fountain pump and other pond equipment. Seek your electrical supplies
dealer for this device.
•
proper functioning of the pump.
•
If necessary, clean the fountain with a soft cloth and change the water frequently. Due to water
evaporation, you may see a buildup of white residue on the fountain surface from mineral con-
tent in the water supply. To prevent such buildup, regularly clean the fountain with soap and
. D
•
be covered under the manufacturer's warranty.
•
This fountain is intended for outdoor use only.
•
See the pump instructions for pump safety, maintenance, and warranty information.
•
The pump on your fountain has no user-serviceable parts. Only an authorized service
representative should service the pump.
CAUTION
1. Install the fountain pump correctly before operating it.
2 DO NOT allow the pump to run dry.
3. For fountains with multiple sections or attached decorations: If any of the fountain's attached sec-
tions with electrical lights or components fall into the water located in fountain base, unplug the
fountain and turn off circuit breaker before trying to put the fountain pieces back in place.
4. If any leakage occurs around the pump housing, turn off the circuit breaker immediately and have
the pump serviced by a registered technician.
5. Do not operate the fountain if the pump has been dropped or has a damaged power cord or plug.
6. If the plug or your wall receptacle gets wet due to water dripping down the power cord or for any
other reason, do not remove the plug from the wall outlet until the circuit breaker is turned off.
NOTE: Allow the pump power cord to hang at a lower level than
the wall outlet to form a "drip loop". This will help prevent water
from dripping down the power cord and getting into the wall outlet.
7. Always unplug the fountain pump and any other independent electrical
accessories (e.g. lights) from the outlet when not in use and before cleaning or replacing parts.
8. Disconnect the power cord from the outlet by holding the plug, not by pulling on the power cord.
9. Do not expose the pump to direct sunlight or to low temperatures for any period of time.
10. Keep the power cord away from high temperatures or heat sources.
11. This fountain pump is not intended for commercial use.
2
GFCI
DRIP LOOP
Publicidad
