Tongue; Hose Holder; Linkage Rods - Bush Hog 4815RR1 Manual Del Operador

Tongue

During shipping tongue is tilted back to-
ward unit.Roll tongue down into working
position. Pin jackstand to tongue.

Hose Holder

Attach the Hose Holder to the mounting
lug on the inside left strut of the tongue.
Use the 5/8" x 2" bolt,5/8" nut and flat-
washer provided.

LINKAGE RODS

Pin the leveling rods assemblies to the
tongue using pin, flatwasher and cotter
pins shipped with assembly. The slotted
casting end should be attached to the
tongue (Position for greasing). It may be
necessary to raise the tongue slightly for
the attachment of the leveling rod. Con-
nect the oppisite end to the center-axle
weldment using the pin and cotter pins
shipped in the leveling rod assembly.
4815/4810/14815/14810
© 2021 Alamo Group Inc.
ASSEMBLY
04/21 Assembly Section 3-3