Aurora AU-A1ZBRC Guía De Instalación Rápida

MODEL AU-A1ZBRC
VOLTAGE (V) 3 V DC
BATTERY TYPE CR2450/DL2450 Lithium Battery
POWER CONSUMPTION 19.8 mW
BATTERY LIFE 2 Years
MAX. OUTPUT RF POWER 8.5 dBm/mW
MAX. NUMBER OF DEVICES 20 Zigbee Devices
OPERATING RANGE 30 M
MAX. AMBIENT TEMPERATURE LIMITS 40°C
IP RATING IP20
PROTOCOL Zigbee 3.0
FREQUENCY BAND 2.40 Ghz - 2.483 Ghz
• There are no restrictions of use.
• Hereby, Aurora Limited declares that the radio equipment type
AU-A1ZBRC is in compliance with Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following internet address:
www.auroralighting.com/ProductDetail/AU-A1ZBRC
USING THE APP TO CONNECT THE REMOTE TO THE HUB
1. Follow instructions on the App to pair the Hub with the AONE remote.
2. Put the module into pairing mode by following the diagram:
The Aone remote will show a constant red indicator that confirms it has
successfully paired with the HUB.
The Aone remote can then be set up using the app.
MOUNTING WALL BRACKET
2
1 IMPORTANT: Ensure it is safe to
screw to the wall
Attach to wall with screws or adhesive
Unclip the back pad provided
REPLACING THE BATTERY
1
PAIRING DEVICE
2
1
Press and hold for 3
seconds, then release
the button
Reset button
www.auroralighting.com
3
Clip on
2
Carefully unclip
battery cover
3
A periodic flash will
confirm remote is
searching for the hub
for 30 seconds
4
Remote is held in
place by magnets
3
4
A constant red light
stays on for 10 seconds
indicating it has paired
successfully
Document Version: AU-A1ZBRC_V2_17