6. USB Drivers
1. Connect the equipment in the PC using the USB cable.
2. If there is an available Internet connection, Windows will silently
connect to the Windows Update website and install any suitable driver
it finds for the device. If no suitable driver is automatically found then
you need to download it from www.tentech.com website. Run the
executable "usb-install.exe" and click in "Install".
The USB output can be used to register measurements in a serial
communication software. The configurations are:
Baud rate: 4800 bps
8 bits - no parity - 1 stop bit (8,n,1)
Note: the resistance units are shown with the following symbols:
uR = micro-ohm
mR = milli-ohm
R = ohm
18