Descargar Imprimir esta página

Ecolab MD421 Instrucciones De Uso página 18

Ocultar thumbs Ver también para MD421:

Publicidad

Idiomas disponibles

Idiomas disponibles

Press "I" on the control panel.
7.2.1.
Long Stops
If long productions stops are planned (more than 6
months) and the pump is emptied of water, it is rec-
ommended that the pump be secured as follows:
1.
Remove the coupling safety guard.
2.
Spray a couple of drops of silicone oil onto
the axle between the top section and the coupling.
Carefully follow the instructions given in the manual
provided by the pump supplier. Never store or install
the equipment where the ambient temperature is
above 40°C or gets at or below the freezing point.
7.2.2.
Start
1. Make sure that the water and air supply to the
unit is open. For air see layout drawing. In case
of central chemical supply this must be activated
too.
2. Select requested function. Use the unit according
to the "User Guide".
18
7.2.3.
1. Close the water supply (see drawing 110003601).
2. Close the air supply.
3. Deactivate chemical supply by pulling up the suc-
tion hose or removing the userpack.
7.2.4.
Remove cover from the unit.
Adjustment of detergent can be done by means of a
110003606
limiting nozzle.
The limiting nozzle is placed in the suction nipple of
the non-retur valve (110003603) and can be re-
placed with a smaller or larger nozzle depending on
the concentration needed, please also see table for
guidelines.
Nozzle size in mm
7.2.5.
Remove the cover from the unit.
Adjust the air pressure on the reduction valve until an
appropriate foam quality is reached.
110003827
Stop
Due to the following it is very important
to close water, air and chemical suplly
when the unit not in use.
• If the air supply is open when the unit
is not in use - air might seep into the
water pipe - which means that the
system has to be bled again.
Adjustment of detergent
All tests have been made with Topax 12
Concentration by 20 Bar in %
0,4
0,5
0,6
0,7
0,8
0,9
1,0
1,1
1,5
Adjustment of air
When setting the regulator, carefully
pull up the knob and turn it clockwise
for pressure increase and counter clock
wise for pressure decrease.
0,75
1,15
1,65
2,20
2,90
3,60
4,40
5,3
9,4

Publicidad

loading

Este manual también es adecuado para:

Md422