Descargar Imprimir esta página

Genesis GLGG08B Manual Del Operario página 8

Publicidad

Idiomas disponibles

Idiomas disponibles

CHARGING THE BATTERY (FIG 3)
NOTE:
Always Check that the power supply corresponds to the voltage on
the ratings plate.
• Connect the charging adaptor (8) and the charging stand (9).
• Plug the adaptor into a 120 Volt AC power source. The GReeN light on the
charging stand will illuminate, indicating the charger is powered.
• Insert the battery (5) all the way into the charging stand until it locks in place
with a click, as shown in FIG 3. The ReD light on the stand indicates that the
battery is charging.
• The light will turn GReeN after charging is complete.
• To remove the battery from the stand, depress the locking tab on the stand
to release the battery pack. See FIG 3.
• Batteries may become warm while charging. This is normal.
• If battery is hot after continuous use in the tool, allow it to cool down to room
temperature before charging. This will extend the life of your batteries.
NOTE:
It takes approximately 3-5 hours to charge up a completely discharged battery.
INSERTING GLUE STICKS (FIG 4)
This glue gun uses standard 11mm (0.43-0.45 in.) diameter glue sticks.
• Make sure the glue gun is on Off position.
NOTE
: The On/Off LeD indicator will light up when the glue gun is
turned on.
• Insert a glue stick through the opening at the back of the glue gun.
Push the glue stick into the glue chamber until it won't go any further.
SWITCH ACTION (FIG 5)
Push the On/Off switch (1) on the back of the glue gun to turn on the
glue gun. The On/Off LeD indicator (2) will light up when the glue gun
is turned on.
Push the On/Off switch one more time to turn off the glue gun.
NOTE:
It takes approximately 20 seconds to get the glue gun ready
for applications.
USING GLUE GUN
• Insert the battery pack and turn on the glue gun.
• Wait 20 seconds to let glue stick to melt so that it flows freely from the nozzle.
• Hold the glue gun firmly. Place the nozzle close to the surface where glue will be applied.
• use two fingers to pull the feed trigger until glue flows from the nozzle. Do not over apply.
• When desired amount of glue has been applied, release the feed trigger.
NOTE
: The glue gun will stop dispensing glue when the glue stick in the chamber is almost used up. To refill
the chamber, point the glue gun down and insert a new glue stick.
• Place the glue gun standing up on a flat protected surface. Place a piece of paper under to catch possible glue
drips.
• Turn off the glue gun when you are finished using the glue gun.
• Always allow the glue stick and glue gun nozzle to be completely cool and remove the battery pack before
storage.
WArNING:
contact with anything while heating or when not in use.
8
Always place the glue gun so that the nozzle does not come in
8V Lithium-ion Cordless Glue Gun
Operator's Manual
5
LOCKING TAB
9
FIG 5
GLGG08B
8
FIG 3
FIG 4
2
1

Publicidad

loading