Troy-Bilt TB25S Manual Del Operador página 7

INSTALLING THE CUTTING HEAD SHIELD
WARNING:
To prevent serious personal injury, never
operate the unit without the cutting head shield in place.
1. Remove the wing nut and washer from the cutting head shield.
2. Insert the short tab (the one without a hole) on the mount
bracket into the slot on the cutting head shield (Fig. 1).
3. Rotate the cutting head shield until the bolt on the cutting head
shield protrudes through the hole on the mount bracket (Fig. 1).
4. Place the washer onto the bolt (Fig. 2).
5. Screw the wing nut onto the bolt until the cutting head shield is
firmly in place (Fig. 2).
CONNECTING THE UPPER AND LOWER SHAFTS
1. Set the unit on a flat, level surface.
2. Turn the upper portion of the unit upside down. The holes on the
coupler should face up (Fig. 3).
3. Turn the lower portion of the unit upside down. The holes on the
lower shaft housing should face up (Fig. 3).
4. Push the lower shaft housing into the coupler (Fig. 3). The holes
on the lower shaft housing should align with the holes on the
coupler (Fig. 4).
IF... the lower shaft housing does not enter the coupler completely
and the holes do not align, remove the lower shaft housing,
rotate the cutting head slightly (1/8th turn) and repeat step 4
(Fig. 5).
5. Insert the screws (x2) into the aligned holes (Fig. 4).
6. Tighten the screws securely with a #2 Phillips screwdriver.
WARNING:
To prevent serious personal injury or
damage to the unit, always make sure that the screws are
securely tightened before each use.
ASSEMBLY
Bolt
Cutting Head
Shield
Bolt
Holes
Coupler
Holes
7
Hole
Fig. 1
Fig. 2
Holes
Fig. 3
Fig. 4
Mount Bracket
Tab
Slot
Wing Nut
Washer
Lower Shaft
Housing
Screws (x2)