Publicidad
Idiomas disponibles
Idiomas disponibles
CONVERSION
Conversion to Propane (LP) / Natural Gas
Instructions
are
for
conversion from
connecting
the
unit
to the gas
Units are shipped from the factory
the conversion. If you have model set up for LP, you will need #43, 42, 41 or 40 Natural Gas orifices.
1) Remove trivets, burners and replace valve orifice fittings with those marked #52 or 53 (for LP (propane) or #43
or 40
for Natural Gas). Reinstall burners and trivets.
2) Before installing regulator, remove regulator cap and flip plastic insert attached to the underside of cap.
Remove
the trivets from the
top of the appliance.
Unscrew hexagonal
top
of
Natural
Gas to
supply.
equipped
for use on natural gas. Either #52 or 53 orifices for LP (propane) are required for
cap
on
regulator.
Propane
(L.P.) or vice-versa. The conversion
Remove the
burners.
Remove plastic insert, flip
over
and snap
back in place.
Page 9
must
be completed
Note
number
on
side
of
valve
Orifice fittings
#43=NAT #53=LP
(Typical Sizing)
Swap
fittings
L.P
Position
of insert.
Replace
hexagonal
cap
and
tighten.
before
,
42, 41
Publicidad
