Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY AND GENERAL INFORMATION
Save these instructions. For your safety, read, understand, and follow the information provided with and on this
device before using. The owner and/or operator shall have an understanding of the device, its operating characteristics
and safety operating instructions before operating the equipment. The owner and/or operator shall be aware that use
and repair of this product may require special skills and knowledge. Instructions and safety information shall be read
to and discussed with the operator in the operator's native language, making sure that the operator comprehends
their contents, before use of this equipment is authorized. If any doubt exists as to the safe and proper use of this
device, remove from service immediately.
Inspect before each use. Do not use if abnormal conditions such as cracked welds, damaged, loose or missing
parts are noted. Any equipment that appears damaged in any way, is found to be worn, or operates abnormally shall
be removed from service until repaired. If the equipment has been or is suspected to have been subjected to an
abnormal load or shock, immediately discontinue use until inspected by a factory authorized repair facility (contact
distributor or manufacturer for list of authorized repair facilities). It is recommended that an annual inspection be
made by an authorized repair facility. Labels and Operator's Manuals are available from the manufacturer.
PRODUCT DESCRIPTION
Long Chassis Hydraulic Service Jacks are designed to lift, but not support, one end of a vehicle. Immediately after
lifting, loads must be supported by a matched pair of appropriately rated jack stands. Air actuated function available
for Model BH6011. Air actuated units require at least 7.8 CFM @ 110 - 175 PSI. A minimum of 150 PSI air pressure
is required to raise rated capacity load.
SPECIFICATIONS
Model
BH6011
Lift Control Valve
(for Air Actuated models only)
Handle Position Lock
Handle Sleeve
Foot Pedal
Capacity
Jack Size ( L x W x H)
10 Ton
54-3/4" x 20" x 12-3/4"
Oil Filler Plug/Screw
(reference parts drawing
Figure 1 - Typical Long Chassis Jack Nomenclature
Min. Height Max. Height Saddle Dia.
7"
Release Valve
(Handle Knob)
Handle
for location)
Grease Fitting
Rear Caster
2
27"
7-3/8"
Saddle
Front Wheel
Publicidad
