König Electronic CMP-UPS500VA Manual De Uso página 2

INDICATION
1. NORMAL (GREEN LED)
2. BACKUP (YELLOW LED)
3. FAULT (RED LED)
4. POWER SWITCH
5. INPUT PHONE JACK
6. OUTPUT PHONE JACK
7. OUTPUT SOCKET
8. INPUT POWER CORD
9. FUSE SET
Installation
Inspection
Inspect the UPS upon receipt. The packaging is recyclable. Save it for re-use or
dispose of it properly.
Placement
Install the UPS in a protected area with adequate airflow, and away from direct sunlight
and excessive dust. Do not operate the UPS where the temperature and humidity is
outside the specified limits in the Specifications Table.
Connect to Utility
Connect the AC input power connector to utility power to power up the UPS.
ENGLISH
STATUS
Lights up when supply is in normal condition and
flashes when UPS is regulating
Lights up when battery is in backup mode and
flashes when battery has a low voltage
Flashes when malfunction or overload occurs
Press the "Power" button for 4 seconds to turn
on/off the UPS.
Insert the phone line into the jack.
Connect to the Tel/Fax/Modem by another phone
line.
Connect with load equipment.
Connect to the AC power outlet
Built-in fuse avoid damage caused by short circuit
or overload.
2