Fluidmaster K-400H-039 Guía De Instalación Rápida página 5

STEP 6: INSTALL NEW FILL VALVE
A: PUSH REFILL TUBE ONTO REFILL
PORT FIRST
B: ATTACH REFILL CLIP TO OTHER END
OF REFILL TUBE
C: INSERT FILL VALVE
Position refill tube to face flush valve making sure fill
valve parts do not interfere with lever arm.
Fill Valve Refill Tube
Overflow
Pipe
Lever Arm
D: ATTACH REFILL CLIP TO OVERFLOW PIPE
Note: If refill tube is too long to fit inside tank
with lid closed, remove refill tube from fill valve
refill port, cut tube, and reattach to port.
E: INSTALL LOCKNUT
Screw locknut onto fill valve shank (below tank).
*Hand-tighten only. DO NOT OVERTIGHTEN.
8
Refill Tube
TOP
DOWN
VIEW
Scissors
(Optional)
STEP 7: FINISHING STEPS
A: ATTACH WATER SUPPLY
CONNECTOR TO FILL VALVE
Twist to the right
*Hand-tighten only.
DO NOT OVERTIGHTEN.
Refill Clip
B: TURN ON WATER
Check for leaks.
C: WATER LEVEL
After the tank stops filling, water level should fill the tank to
roughly ½ inch below top of overflow pipe to ensure a
proper flush. (Does not need to be exact.)
**Lever Hole
* Overtightening may damage fill valve or coupling nut, potentially causing flooding. Make sure
the float cup does not touch the tank walls or tank lever and flush valve.
**
The top of the overflow pipe must be a minimum of 1" below tank lever hole.
Top of
Overflow Pipe
1/2"
Water Level
Overflow Pipe
9