Publicidad
Idiomas disponibles
Idiomas disponibles
3 41 01 166 21 0.book Seite 18 Mittwoch, 7. September 2011 2:23 14
en
18
Instructions for core drilling.
Punch-mark the marked drilling location.
Rotate the cutting tool downward until the
pilot pin centers on the punch-mark.
Carefully begin the drilling process until a
groove has been established on the cutting
surface.
Do not stop the drill motor during the
drilling procedure.
Only remove the cutting tool from of the dril-
ling hole while the motor is running.
If the carbide tipped cutter should remain
stuck in the material, stop the drill motor and
carefully turn the carbide tipped cutter out
clockwise.
Remove the chips and the slug after each dril-
ling process.
Do not touch the chips with your bare
hand. Always use a chip hook.
When changing a cutting tool, pay attention
not to damage the cutting edges.
When core drilling layered material, use a
Slugger ID sharpened cutter for stack drilling.
Publicidad
