Police Force PFMTF50 Manual De Instrucciones página 2

Insert the fully charged battery into the flashlight. The positive (+) end of the battery
2.
should be inserted first (toward the head of the light) as shown in the diagram below.
Screw the end cap back on by turning it clockwise.
(flashlight)
USING THE FLASHLIGHT
To turn on the light, press the rubber Push Button Tail Switch (located at the
1.
opposite end of the light) until it clicks and the light turns on. This unit features
three light modes: High, Low, and Strobe.
To change the light mode, "soft press" the rubber Push Button Tail Switch by
2.
applying light pressure (if you press too hard it will click and turn off).
To adjust the focus, (with the light facing away from you) grasp the handle with
3.
one hand then use the other hand to move the Slide Zoom forward or backward.
To turn the flashlight off, press the rubber Push Button Tail Switch until it clicks.
4.
WARRANTY
Cutting Edge Products, Inc. extends a Lifetime warranty to the PFMTF50 for the product
against defects in materials or workmanship, with the following exceptions:
1. The warranty does not cover damage resulting from accident, misuse or abuse,
lack of reasonable care, the affixing of any attachment not provided with the
product, loss of parts, or recharging the unit in any manner not in accordance with
the instructions above.
2. The warranty will be voided if the unit has been opened (with the exception of
inserting the batteries according to the directions above) or tampered with in any
way (unless by an Authorized Dealer) or if any unauthorized replacement parts
have been used.
3. The lifetime warranty extends only to the flashlight and LED bulb only. The battery
is excluded from the warranty because it will be damaged if the charging
instructions above are not followed.
CONDITIONS OF SALE
Purchase of this product is an agreement by the purchaser/user to hold all sellers and
manufacturers harmless of all liabilities and damages.
TO OBTAIN SERVICE
Contact the Authorized Dealer from whom you purchased this unit for Return Merchandise
Authorization (RMA). The return unit must be sent postage prepaid and proof of purchase
is required. Damage or loss occurring during shipment is not covered by this warranty.
Positive
(+)
Negative
(-)
Revised 9/25/2018
(End cap)