LE MARQUIER PLFE150DC Manual De Uso página 6

EN
1. Ensure the thermostat's button is set to 0 before connecting the plancha's male connector to the power source.
2. Set the temperature by turning the thermostat's button. The heat comes on and the orange light turns on.
3. When the cooking surface reaches the set temperature, the plancha stops heating and the orange light automatically
turns off. The orange light turns on again when the cast-iron plate's temperature goes below the thermostat's set
temperature.
The appliance will operate by turning on and off in order to maintain the user's set and desired temperature.
4. You can set the desired temperature from 0 to 300°C when cooking.
5. Before cooking, pre-heat the plancha for approximately 10 minutes at 300°C.
6. After cooking, position the thermostat's button on 0 and disconnect the power supply.
7. When you are no longer using your plancha, store it in a dry place.
NOTE: You can recover your food's cooking juices by placing a collecting tray under the channel provided for that
purpose.
CONDITIONS OF USE
 When in use, the accessible parts may be very hot.
 Any modification made to the appliance could be dangerous.
CLEANING AND SERVICING
To clean your plate, leave it on the frame of the plancha. It only takes one minute to clean your plate. Cleaning must
be carried out when the plancha is turned off but while the plate is still warm. If this is not the case, continue to operate
the plancha for another few minutes. Scrape the largest residues using a stainless steel scraper. Pour water on the
plate and scrub using stainless steel wool. Renew the operation until the plate is spotless. Carefully wipe with a paper
towel.
Be careful with the capacity of the collecting tray: do not forget to empty it on a regular basis. Use protective gloves if
the tray is still warm.
Check out our tutorial on our YouTube channel.
CAUTION: The ice cube method is to be avoided. It presents a risk of thermal shock which could damage the plate
(flaking of the enamel, for example).
When you are no longer using your PLANCHA, store it in a dry place or cover it in order to prevent the deposit of dust
and moisture.
SAFETY
In the event of an electrical failure, the appliance will stop heating at 270°C and will automatically stop the heat's
power supply. Immediately disconnect the power cable and contact the Aftersales Department or a licensed electrician.
The power cable must be checked on a regular basis in order to detect any signs of deterioration and if the cable is
damaged, the appliance must not be used.
Every appliance is inspected at every manufacturing stage. In the event that anomalies were to be detected, it is
important to ensure all the requirements of the manual have been strictly adhered to. Failure to follow the rules laid
down for use of the appliance can lead to its deterioration.
30 RUE AMBROISE 1 I 40 390 ST MARTIN DE SEIGNANX (France)
Tél +33 (0)5 59 56 60 70 - Fax +33 (0)5 59 56 10 79
lemarquier.com