Rico Ric T50-66S Ric T50S Instrucciones página 39

(A)
(C) T50S / T60S / T70S / T80S
Danger due to rotating parts: impeller!
The danger of shearing due to the rotating impeller can exist even when the machine off, if it is started manually.
Therefore use suitable work clothes and personal protection equipment.
The position of the silencer housing can be changed by using the manifold (on request).
NOTE FOR THE USER
See silencer housing repositioning diagrams in the first section.
12.3.1 90° MANIFOLD (accessory) USE
•
For different connection configurations, use the 90° manifold installed
only on the cover openings.
•
See the possible configurations as previously illustrated.
Fitting the 90° manifold
•
Remove the silencer as previously described.
•
Insert the gaskets between the cover and manifold.
•
Tighten the respective screws
•
Assemble the silencer by proceeding in reverse order.
See par. 5.1 for INSTALLATION CONDITIONS
12.4 VERTICAL INSTALLATION ON THE COVER
The units can be installed with the working axis vertical, as follows:
•
Using vibration dampers fitted directly on the cover, without manifold.(E)
•
Using a special foot for vertical fixing, available as an accessory.(F)
Non-compliance with the unit's intended use can cause serious
injury.
Regularly check the fixing of the unit to the support structure.
Excessive vibration of the unit can seriously damage the machine.
Avoid the possibility of water stagnation, especially in case of
ATTENTION!
installation of the unit with vertical axis.
 Druckluftanlagenbau GmbH
RIC T50S – T120S
(B) T50S / T60S
Tel. +49 ( 0 ) 2151 9931 99 -
39 / 120
(B)
T70S / T80S / T90S / T100S / T110S / T120S
(C) T90S / T100S / T110S / T120S
–
vk@rico-druckluft.com www.seitenkanalverdichter.de
E