Descargar Imprimir esta página

Uline H-9471 Manual Del Usuario página 3

Publicidad

Idiomas disponibles

Idiomas disponibles

LOCKING THE MOUNTING BRACKET
1.
Using needle-nose pliers, detach the locking pin
from the mounting bracket. (See Figure 4)
Figure 4
Locking Pin
2. Insert the locking pin through the hole on the back
of the smoke/CO detector. (See Figure 5)
Figure 5
3. When attaching the smoke/CO detector to the
mounting bracket, the locking pin's head will fit into
a notch on the bracket.
PAGE 3 OF 9
INSTALLATION CONTINUED
Locking Pin
1-800-295-5510
UNLOCKING THE MOUNTING BRACKET
1.
Insert a flathead screwdriver between the mounting
bracket and the locking pin. (See Figure 6)
Figure 6
2. Pry the smoke/CO detector away from the bracket
by pushing up the screwdriver and turning the
smoke/CO detector counterclockwise at the same
time.
uline.ca
0721 IH-9471

Publicidad

loading