Publicidad
Idiomas disponibles
Idiomas disponibles
English
Spring clip speaker terminals
The spring clip speaker terminals deliver amplified, speaker-level signals as
output and should be connected with the passive speakers.
Aux Input Connection
You can connect an audio device to this unit and play your music through its
speakers. To do this, set the Function Knob to Bluetooth mode, connect the 3.5
mm auxiliary cable between your audio device, and the Aux In Jack of this unit
and start playing the music.
Turntable Operation
1. Push the On/Off Switch to turn on the power.
2. Set the Function Slider to PHONO position.
3. Set the Speed Switch accordingly.
4. Place the record on the turntable. Use the 45 RPM Adapter if necessary.
5. Remove the stylus protector from the stylus assembly.
Note: To avoid stylus damage, make certain the included stylus guard is in place
whenever the turntable is being moved or cleaned.
6. Release the tonearm Hold Down Clip.
Note: When the turntable is not in use, remember to lock back hold down clip.
7. Lift up the tonearm and move it over the record where play is desired to
begin. Gently put down the tonearm and begin the playback.
8. When the record is finished playing, gently lift up the tone arm and move it
back to the tonearm rest.
9. Lock the Hold Down Clip to secure the tonearm.
Pitch Control
The turntable speed can be increased or decreased by approximately 10% by
rotating the Pitch Control Knob. To increase the speed, turn the Pitch Control
Knob clockwise. To decrease the speed, turn the knob counter-clockwise.
6
Publicidad
