Publicidad
Idiomas disponibles
Idiomas disponibles
Unpacking
Carton Contents
• Electric pressure washer with lower handle frame
• Upper handle frame
• Spray wand
• Trigger gun
• Hose holder panel
• Trigger gun holder
• Power cord holder
• Wheels (2)
• Hardware (2 wheel washers, 2 cotter pins, 2 thumb screws,
2 thumb screw washers, 2 nuts)
• Five (5) Quick-Connect nozzles (0º, 15º, 25º, 40º and Soap)
• Needle clean-out tool (included with manual packet)
• High-pressure hose
• Manual with registration card
1. Carefully remove the pressure washer and check to see
that all of the above items are supplied.
2. Inspect the product carefully to make sure no breakage or
damage occurred during shipping. If you find damaged or
missing parts, DO NOT return the unit to the store. Please
call the Snow Joe
+ Sun Joe
®
1-866-SNOWJOE (1-866-766-9563).
NOTE: Do not discard the shipping carton and packaging
material until you are ready to use your new electric
pressure washer. The packaging is made of recyclable
materials. Properly dispose of these materials in
accordance with local regulations.
IMPORTANT! The equipment and packaging material are not
toys. Do not let children play with plastic bags, foils, or small
parts. These items can be swallowed and pose a suffocation
risk!
m
WARNING!
Do not connect to power supply until
assembly is complete. Failure to comply could result in
accidental starting and possible serious personal injury.
Assembly
1. Insert the wheel shaft into the holes on the wheel clamp.
Assemble the washer on the other side of the wheel shaft
(Fig. 1).
customer service center at
®
Fig. 1
Lower handle frame
2. Fix the wheel by inserting the cotter pin into the hole on
the end of the wheel shaft, as shown (Fig. 2).
Fig. 2
3. Repeat the above steps for the other wheel.
4. Fit the hose holder panel on the front of the upper handle
frame and the power cord holder on the back left side of
the upper handle frame, align the holes (Fig. 3).
Fig. 3
7
Wheel clamp
Washer
Wheel
Cotter pin
Upper handle
frame
Power cord
holder
Hose holder
panel
Publicidad
