Axxess AXRC-GMLN10 Instrucciones De Instalación página 2

From the AXRC-GMLN10 harness to the aftermarket radio, connect the:
• Black wire to the ground wire.
• Yellow wire to the battery wire.
• Red wires (2) to the accessory wire.
• Blue/White wire to the amp turn on wire (excluding Bose). This wire must be connected to
hear sound from the factory amplifier.
• Orange wire to the illumination wire (if applicable).
• White wire to the front left (+) speaker output.
• White/Black wire to the front left (-) speaker output.
• Gray wire to the front right (+) speaker output.
• Gray/Black wire to the front right (-) speaker output.
• Green wire to the rear left (+) speaker output.
• Green/Black wire to the rear left (-) speaker output.
• Purple wire to the rear right (+) speaker output.
• Purple/Black wire to the rear right (-) speaker output.
2
CONNECTIONS
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Blue/Pink wire to the VSS/speed sense wire.
• Green/Purple wire to the reverse wire.
• Light Green wire to the parking brake wire.
• Yellow RCA jack to the backup camera input. (If the vehicle is equipped with a factory backup
camera.)