Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
1
Installing the faucet assembly
CAUTION : Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
Shut off the water supply. Remove the old
faucet.
Clean off the mounting surface.
Remove the lock nuts (E), metal washer (D), and
rubber washer (C) from the faucet.
WITHOUT DECK PLATE: Insert the supply lines (H)
and lift rod (P) through the mounting hole in the
sink until faucet (A) sets on top of the sink.
WITH DECK PLATE: Align the hole in the gasket
(G) and deck plate (F) with the mounting hole in
the sink. Insert the supply lines (H) and the lift
rod (P) through the deck plate (F) and mounting
hole in the sink until faucet (A) sets on top of
deck plate (F).
F
1
NOTE: If the sink is uneven, use silicone under the
gasket (G).
A
P
H
G
2
1
2
Securing the faucet
Slide the rubber washer (C) and metal washer
(D) over threaded rods and lift rod (P). Use the
lock nuts (E) to secure the rubber washer (C)
and metal washer (D).
Attach the extension rod (U) to one lock nut
(E), feed a screwdriver (not included) through
the bottom of the extension rod (U), and then
tighten the lock nut (E). Repeat for the second
lock nut (E).
1
A
P
H
4
P
2
C
D
E
U
Publicidad
