Danby Designer DAR110A1WDD Manual Del Propietário página 6

OPERATING INSTRUCTIONS
DOOR REVERSAL INSTRUCTIONS
If the appliance is placed on its back or side for any
length of time during this process, it must be allowed
to remain upright for 6 hours before plugging it in
to avoid damage to the internal components.
To change the direction of the door swing, follow
the instructions below.
1. Remove the lower hinge and adjustable foot
from the lower right side of the cabinet. Remove
the adjustable foot from the lower left side of the
cabinet.
2. Remove the door from the cabinet. Remove the
screw hole cover from the top left side of the
door and install it on the top right side of the
door.
3. Remove the hinge pin from the top right side of
the work top and install it on the top left side of
the work top.
4. Reinstall the door on the cabinet. Install the
lower hinge on the bottom left side of the
cabinet. Install both adjustable feet.
Note: Ensure that the rubber gasket on the door is
making a good seal with the cabinet all the way
around before tightening the screws.
1
2
3
5
4