Publicidad
Idiomas disponibles
Idiomas disponibles
SAVE THESE INSTRUCTIONS!
SPECIFIC SAFETY RULES
DO NOT let comfort or familiarity with product
replace strict adherence to cordless product
safety rules. If you use this tool unsafely or incorrectly, you
can suffer serious personal injury.
1 . Hold tool by insulated gripping surfaces when performing an
operation where the accessories may contact hidden wiring .
Contact with a "live" wire will also make exposed metal parts of
the tool "live" and shock the operator .
2 . Be aware that this tool is always in operating condition, because it
does not have to be plugged into an electrical outlet .
3 . Always be sure you have firm footing .
4 . Be sure no one is below when using the tool in high locations .
5 . Hold the tool firmly and use both hands .
6 . Keep hands and hair away from moving parts .
7 . Do not leave the tool running . Do not force tool to stay in the "on"
OPERATING INSTRUCTION
Installing Or Removing Battery Pack
(See Fig.1, Fig.2)
1 . Make sure the switch is in the "off" position before insertion/
removal of a battery pack .
2 . To remove a battery pack, depress both tabs on either side
of the battery and pull downward .
3 . To insert a battery pack, align the battery with the tool housing and
push battery inward until click indicating battery is fully installed .
Charging The Battery Pack
(See Fig.3)
1 . Your new battery pack is not fully charged . You need
to charge it before use .
2 . Battery may not charge when it is above a certain preset
temperature limit . Allow temperature of battery to cool before charging .
3 . The charge process will take less than one hour .
4 . After charging, unplug the charger from the power source and stow
away in a safe place .
To Swap Arm Assemblies:
1 . Unscrew two T10 screws on Belt Arm Assembly (7, or 7-1) .
2 . Remove Belt Arm Assembly (7, or 7-1) and Belt Support Assembly (19, or 19-1)
3 . Install new belt arm assembly and belt support assembly .
4 . Reinstall the two (T10) screws .
MCL16RS
MCL1613BS MCL1618BS 16V BELT SANDER
position . Operate the tool only when hand-held .
8 . Do not touch the workpiece immediately after operation; it may be
extremely hot and could burn your skin .
9 . Some material contains chemicals which may be toxic . Take
caution to prevent working dust inhalation and skin contact .
Follow material supplier safety data .
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
Fig. 2
Fig. 1
Contact Wheel
Push to release
arm tension
3
Fig. 3
Push to roatate
arm assembly
( 8 indexing positions)
Push down
to open cover
to install or
remove belts
08/13/18
Publicidad
