PARTS IDENTIFICATION (Fig. A)
1. Water tank
2. Water tank lid
3. Handle
4. Battery slot cover
5. Battery slot (for 10.8 V - 12 V max battery cartridge)
6. Battery slot (for 18 V and 14.4 V battery cartridge)
7. Filter
8. Filter holder
9. Cafe pod holder
10. Overflow opening
11. Cup rest
12. Power lamp
13. Power switch
14. Coffee cup cover
15. Coffee cup
PREPARATION
CAUTION
• Always switch off the appliance before installing or
removing of the battery cartridge.
• Hold the top of the appliance and the battery cartridge
firmly when installing or removing battery cartridge.
Failure to do so may cause them to slip off your hands
and result in damage to the appliance and battery
cartridge and a personal injury.
• Always install the battery cartridge fully until the red
indicator cannot be seen. If not, it may accidentally
fall out of the battery holder, causing injury to you or
someone around you.
• Do not install the battery cartridge forcibly. If the
cartridge does not slide in easily, it is not being inserted
correctly.
• Always install the battery to the suitable slot for the
battery cartridge to be used.
When using the appliance first time, or after long period of
storage, perform the following steps:
1. Remove all packing materials from the appliance.
2. Clean the appliance exterior and wash all removable
parts. (refer to the "Daily cleaning" section for
removable parts)
3. To clear any residue from the appliance, pour 240 ml
of fresh water into the water tank and brew without
ground coffee or cafe pod until the water tank gets
empty. Repeat the same operation at least twice.
(refer to the "Brewing" section for how to brew)
Installing or removing battery cartridge (Fig. B)
To install the battery cartridge (17), slide the battery slot
cover (16) to open the battery slot that you are going to
use ((6) for 18 V or 14.4 V battery cartridge, (5) for 10.8
V - 12 V max battery cartridge). Align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place with
a little click. If you can see the red indicator (18) on the
upper side of the button (19), it is not locked completely.
To remove the battery cartridge, slide it from the appliance
while sliding the button on the front of the cartridge.
Battery protection system
The appliance is equipped with a battery protection
system. This system automatically cuts off power to the
appliance to extend battery life.
8
The appliance will automatically stop during operation if
the appliance and/or battery are placed under one of the
following conditions:
• Overheated:
If the appliance does not start, the battery is
overheated. In this situation, let the battery cool
before pressing the power switch again.
• Low battery voltage:
If the remaining battery capacity is too low, the
appliance will not operate. The power lamp blinks in
this situation. Remove and recharge the battery.
NOTE
• The overheat protection works only with a battery
cartridge with a star mark (Fig. J).
Indicating the remaining battery capacity (Fig. K)
(Only for battery cartridges with the indicator)
Press the check button (21) on the battery cartridge to
indicate the remaining battery capacity. The indicator
lamps (20) light up for few seconds.
Indicator lamps
Lighted
Off
Blinking
(For 18 V and 14.4 V
batteries only)
(For 18 V and 14.4 V
batteries only)
NOTE
• Depending on the conditions of use and the ambient
temperature, the indication may differ slightly from the
actual capacity.
OPERATION
CAUTION
To reduce the risk of scalding, follow the instructions
below:
• Do not remove the filter holder/cafe pod holder during
the brewing cycle. Steam builds up under the filter
holder/cafe pod holder.
• When the brewing section marked with
do not touch it. (Fig. L)
• Be aware that hot coffee drips from the bottom of the
filter holder/cafe pod holder even after the brewing
cycle.
Remaining capacity
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the battery.
The battery may have
malfunctioned.
is steaming,