44
TROUBLESHOOTING
The table includes some of the most common problems, their causes and remedies
PROBLEM
No power supply
Machine does
Faulty power supply.
not start
Pump locking ring too tight.
Filter is blocked.
Not enough
Inlet connection is not good, air in the inlet
water comes
pipe.
out, working
pressure is
Valve is blocked.
uneven
Outlet nozzle is not smooth.
3 drops of water every minute is permissible,
Water leakage
but if more water leaks out, the seal may be
in the pump
worn.
Pressure control worked.
Engine stops
suddenly
Thermal protection may have switched off the
motor to prevent overheating.
NOTE: In the event of not being able to resolve the problem, get in touch with an Authorised
Service Centre.
TRANSPORTATION AND STORAGE
•
Remove the plug from the power socket and disconnect the machine from the water before transporting or
storing the pressure washer.
•
Use the wheels to transport the machine. Hold the appliance by the handle and pull it.
•
Clean the detergent tank before storing the machine.
•
Always store the product in a clean, safe, dry place with temperatures between 0º and 45ºC.
•
The equipment is not weatherproof and should not be stored in direct sunlight, at high temperatures or in damp
places.
•
The machine when not in use should be stored clean, on a flat surface.
•
Store the machine out of the reach of children.
POSSIBLE CAUSE
SOLUTION
Contact after-sales service.
Clean the filter.
Check the connection, tighten the gasket.
Check if the hose is clogged or if there is not
enough inlet water.
Clean the valve and reinstall it.
Contact after-sales service.
Contact after-sales service.
Check if the outlet nozzle is blocked. Clean
the nozzle.
Turn off the cleaner, leave the machine for a
few minutes to cool down.