HAIRCUT EASY'LISS BSI3 Manual De Usuario página 13

1.5 Safety instructions
The electrically heated hairbrush is designed for
use in a hairdresser's salon, in compliance with
the following points:
Electrical hazards
Make sure that the power supply voltage
shown on the nameplate (Fig. 2)
corresponds to that of your electrical installation.
To provide additional protection, it is
recommended to install in the electrical circuit
supplying the equipment a rated residual
differential current device (RDD) not exceeding
30 mA. Request advice from your installer.
equipment immediately. Contact the dealer or his
after-sales service to obtain a replacement lead.
Regularly check the condition of the
electrical lead. If the lead shows any
signs of damage, stop using the
The electrical lead must always be
fully unrolled before it is connected
to a power socket.
13
EN