Publicidad
Idiomas disponibles
Idiomas disponibles
Lighting the Fireplace
1. Read and understand all operating instructions before lighting.
2. Before beginning, make sure the key valve is in the "OFF" position.
3. Connect the gas line to the tank by turning the connection knob clockwise. Hand-tighten only.
4. Slowly open the valve on your LP gas tank.
5. Position a burning long match or long burning butane lighter near the side of the burner.
6. Insert the key and slowly turn the key valve counterclockwise toward the "ON" position.
7. Once the burner has been lit, remove the match/lighter. Observe the flame and make sure
that all of the burner ports are lit.
8. Adjust the flame to the desired height using the key valve.
WARNING: If ignition does not occur in 15 seconds, turn the key valve to the "OFF"
position and turn the gas o
the fireplace and wait at least 5 minutes until the gas has cleared to repeat the lighting
procedure. Failure to do so could result in a large flashback of collected gas, causing
property damage, serious injury, or death.
ON
Shut-O
Instructions
1. Turn the key valve clockwise to the "OFF" position.
2. Once the flame is out, remove the key and close the valve on the LP gas tank to shut o gas flow.
3. Store the key in a safe location. If the key is lost please contact Real Flame Customer Service at
1-800-654-1704 for a replacement.
LIGHTING INSTRUCTIONS
at its source. Make sure there is no source of ignition around
Flame Height
OFF
10
8-14"
(20.3-35.5 cm)
Publicidad
