Beurer babycare BY 52 Instrucciones Para El Uso página 13

9. Disposal
In the interests of environmental protection, these devices must not be disposed of in the
household waste at the end of their service life. They should be disposed of at the appropriate
regional collection points.
Please observe local regulations when disposing of materials.
Please dispose of the device in accordance with EC Directive – WEEE (Waste Electri-
cal and Electronic Equipment).
If you have any queries, please contact the appropriate local authorities.
10. technical data
Operating voltage:
Power consumption:
Heating time:
Temperature for keeping warm:
11. troubleshooting
Fault
Water leaks from the bottom
of the device when in use.
The warming process does
not start or does not end.
No LED display
The baby food warmer does
not switch on once it is
plugged in.
The temperature on the
display does not increase
once the warming process is
started; the device switches
itself off after a while.
The food is not warm at the
end of the warming process.
220–240 V ~ / 50/60 Hz
80 watts
3 - 18 min.
35 °C - 85 °C
Cause
Device faulty
Thermostat broken
Mains plug not (correctly)
plugged in or device faulty
No electricity
No water in the device
Not enough water in the
device
Action
Switch off the device imme-
diately, unplug it, let the
water drain out and return the
device to the retailer.
Switch off the device imme-
diately, unplug it, let the
water drain out and return the
device to the retailer.
Check that the mains plug
is (correctly) plugged in. If
there is still no display, switch
off the device, unplug it and
return it to the retailer.
Check that the mains plug is
correctly plugged in.
Unplug the device, let it
cool down, then fill it with
water and start the warming
process as described in these
instructions.
Unplug the device, let it cool
down, then fill it with sufficient
water and start the warming
process as described in these
instructions.
13