Publicidad
Idiomas disponibles
Idiomas disponibles
For aid in identifying hardware, see hardware identifier on page 9.
1. Lay table top #1 painted side down, on a smooth, flat
surface. Use the shipping container to protect the
painted surface of the table top.
2.
Align U-Support (#7) and U-Leg (#2) on Table Top as
shown in Figure 1. Note: "U" Leg is Larger and
wider than U-Support. The U-Leg should be
installed on the end of the table half with the
end rail mounting indentations..
3. Put plastic caps #13 on the end of U-leg #2.
CAUTION:
WHEN ASSEMBLING TABLE, IT IS EXTREMELY IMPORTANT THAT THE U-
CLIPS (#3) BE TURNED AS SHOWN HERE. IF U-CLIPS ARE TURNED
INCORRECTLY, YOU WILL DO IRREPARABLE DAMAGE TO YOUR TABLE
WHEN YOU ATTEMPT TO OPEN IT TO THE PLAYING POSITION.
If you want to see a video on how to position the U-Clips go to:
http://www.escaladesports.com/customer-service/videos.html
4. Align the holes in the Large U-clips #3 with indentations in
table top assembly and secure with twenty four screws #20
as shown. All four holes in each U-Clip must align with four
indentations in top.
IMPORTANT:
Be sure that slot in the six U-clips #3 all face the same
direction (toward the middle of the table with the U-
support) as shown.
3
small so look closely
This end is the middle of the table
and has no stripe or indentations.
Figure 1
13
Plastic
Cap
indentations are
End Rail
Mounting
Indentations
This end is the middle of the table
and has no stripe or indentations.
20
3
3
IMPORTANT: U-Leg is wider than U-support.
Make sure they are assembled exactly as
shown. If not, there will be a large gap between
table halves and table will not operate properly!
2
1
Table Top
7
U-support
2
U-Leg
All screws shown
are (#20) sheet
3
metal screws.
3
3
13
Plastic
Cap
3
7
U-support
2
U-Leg
Figure 2
Publicidad
