ELECTROTEK ET-F16SFv2 Manual De Instrucciones página 8

COMPONENTS.
ASSEMBLY (STEP BY STEP).
1. Screw the mast(M) to the base(P) with the screws(O).
2. Remove the nut (L) from the mast, insert the trim (N) and put the nut (L) back on.
3. Extend the mast(M), pulling out the extension bar(K) and tightening the nut(L).
4. Insert the fan body into the extensible bar (K) and tighten with the nut (J).
5. Put the rear grille(E) and fix it with the nut(D).
6. Put the blades (C) and fix them with the nut (B).
7. Open the tabs of the rear grille, put the front grille (A) and close the tabs.
NOTE.
Each of the pieces of the photos in this section may be subject to small
variations in the piece model.
In any case they are mounted in the same way and following the same steps.
A. Front Grille.
B. Blade fastening nut.
C. Blades.
D. Rear grille retaining nut.
E. Rear Grille.
F. Motor shaft.
G. Motor body casing.
H. Oscillation Button.
I. Button panel.
J. Fan body adjustment nut.
K. Internal bar of the extendable mast.
L. Extendable mast fastening nut.
M. Extendable mast.
N. Trim covers base screws.
O. Screws fastening the mast to the base.
P. Base / Foot.