Publicidad
Idiomas disponibles
Idiomas disponibles
Operating your French Door
Refrigerator
USING THE CONTROL PANEL
RF323TE**
1
2
3
10
7
( 1 ) Energy
Touching this button turns Energy Saver
Saver
mode on and off. When you turn Energy
Saver on, the Energy Saver icon lights.
Turn Energy Saver off and the icon
goes off. The Energy Saver function
automatically turns on when power is
supplied to the refrigerator.
If condensation or water drops appear
on the doors, turn the Energy Saver
mode off.
( 2 ) Freezer
Touch this button to set the freezer to
(Hold 3 sec
your desired temperature.
for Power
You can set the temperature between
-8°F and 5°F (between -23°C and
Freeze)
-15°C). Touch and hold this button for 3
seconds to decrease the time needed
to freeze products in the Freezer. It can
be helpful if you need to quickly freeze
easily spoiled items or if the temperature
in the freezer has warmed dramatically
(For example, if the door was left open).
( 3 ) Alarm
This button serves two purposes:
/ hold 3sec
1) To turn the door open alarm on and off
for Filter
If the door alarm is set to On, an alarm
beeps if any refrigerator door is left
Reset
open for more than three minutes.
The beeping stops when you close the
door. The door alarm function is pre-
set to On in the factory. You can turn it
off by touching and then releasing this
button. You can turn it back on in the
same fashion. The icon lights up when
the function is on.
2) To reset the water filter life indicator.
After you replace the water filter, touch
and hold this button for 3 seconds to
reset the water filter life indicator.
12_ operating
DA68-02603A-03.indb 12
Lighting/
Hold 3 sec
for C↔F
4
5
( 5 ) Fridge
6
(Hold 3sec
for Power
9
Cool)
8
( 6 ) Ice Off
(Hold 3 sec
for child
(7) Cubed
(8) Crushed
(Cubed) (Crushed)
Cooling Off
Mode
( 4 )
Touching this button turns on the
Dispenser LED lamp (under the display)
in continuous mode so that it stays on
continuously. The button also lights
up. If you want the Dispenser lamp to
come on only when some one uses the
dispenser, touch this button to turn the
continuous mode off. Touch and hold
this button for 3 seconds to switch the
temperature units between °C and °F.
Touch this button to set the fridge to
your desired temperature. You can set
the temperature between 34°F and 44°F
(between 1°C and 7°C). Touch and hold
this button for 3 seconds to decrease
the time needed to cool products in
the Refrigerator. It can be helpful if you
need to quickly cool easily spoiled items
or if the temperature in the fridge has
warmed dramatically (For example, if the
door was left open).
If you don't want to make more ice,
touch this button. Also, pressing this
button for 3 seconds turns on Child
Lock which locks the display panel and
lock)
dispenser buttons so the buttons can not
be used. The Child Lock icon lights up to
indicate you've activated the Child Lock
function. Press 3 seconds to unlock.
Press the Cubed Ice or Crushed Ice
button to select the type of ice you
Ice
want dispensed. Each time you press
the button, the cubed and crushed
Ice
ice modes alternate and the Cubed or
Crushed ice icon lights up, indicating
your selection.
If you don't need ice, turn the function
off to save on water and energy
consumption (See Ice Off below).
Cooling Off mode (also called Shop
mode), is designed for use by retailers
when they are displaying refrigerators on
the shop floor. In Cooling Off mode, the
refrigerator's fan motor and lights work
normally, but the compressors do not
run, and the refrigerator and freezer do
not get cold. To start Cooling Off mode,
touch and hold the Energy Saver button
and the Freezer button for 5 seconds
during normal operation. The refrigerator
chime sounds and the temperature
display flashes OF OF.
To cancel Cooling Off mode, touch and
hold the Energy Saver and the Freezer
buttons again for 5 seconds.
13. 4. 25.
2:12
Publicidad
