ASSEMBLY
IMPORTANT!
To ensure safe operation of your stroller,
please follow these instructions carefully. Please keep these
instructions for future reference.
IMPORTANT!
Before assembly and each use, inspect
this product for damaged hardware, loose joints, missing parts
or sharp edges. NEVER use if any parts are missing or broken.
IMPORTANT!
Adult assembly is required.
Remove stroller from box. The front and rear
wheels
be installed prior to use.
MUST
FRONT WHEEL
To attach the front wheel, unfold stroller as
described in the following section:
• Unlock the release lever (Fig. 1a).
1)
• Unfold stroller frame by pulling backward
on the stroller handle (Fig. 1b).
• To attach the front wheel, lean the
stroller back so that it rests on the
handle with the front and rear legs
pointing upward. Position the front wheel
over the front leg tube so that the hole in
the housing lines up and will slide onto
the leg (Fig. 1c). Firmly push down until
the wheel lock securely into place.
NOTE : Tug on the wheel to ensure it is
securely attached.
3
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
REAR WHEELS
Attach the rear axle assembly and wheels as
follows:
• Position axle assembly over the rear leg
2)
CHILD TRAY
• To attach the child tray, push the angled
3)
Fig. 1a
Fig. 1b
Fig. 1c
tubes, brake pedals facing back. At the
same time, push down applying equal
pressure to both sides until they lock into
place (Fig. 2).
NOTE : NEVER use stroller if wheels do
not lock into place.
side of the tray onto the post at the
end of the right armrest while pressing
downward on the snap button, until
locking in place (Fig. 3a). Rotate the tray
downward until it latches onto the left
armrest into place (Fig. 3b).
CAUTION: The maximum weight that
can be carried in the child tray is 3
lbs (1.36 kg).
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Fig. 2
Fig. 3a
Fig. 3b
Fig. 3c
4