MHTeam EH5-15 Manual De Instrucciones página 3

4. Preliminary Instructions
Take the heater out from its carton. If the unit is somehow damaged, do not use it and
contact your dealer.
Put the heater on a flat, level, non-flammable, solid surface. Connect the plug to the
appropriate 400V 50Hz 3phase electrical
Ensure a minimum of 1 m safety clearance between the heater and any surrounding
objects and materials, on all sides.
Only operate the heater in normal upright position.
Do not place the heater near walls, corners or low ceilings.
Do not place the heater below a socket outlet.
Do not place the heater on moving vehicles or where it can tip over.
Keep the heater away from flammable, combustible, explosive or corrosive materials.
Keep the heater away from curtains or similar materials that could block the air inlet and
outlet.
Keep the power cable away from heat sources, sharp edges, cutting and moving parts.
For indoor use only. Do not expose to the weather or to humidity.
Do not place the heater in the immediate surroundings of a bath, shower or swimming
pool.
Do not use plug adaptors.
5. Instructions for Use
Before switching the heater on, position the heater so that it stands upright on a firm
surface and at a safe distance from wet environments and flammable objects.
Start
Set the thermostat knob to the MAX position and let the heater operate with full power.
The fan heater will switch on when the heating selector is set to one of the power settings.
Once the room reaches the required temperature, heating element will stop working. The
fan heater now starts and stops automatically and thus keep the room temperature
constant.
Shut-down
Before switching off the heater, please turn the thermostat to MIN position and turn the
switch to fan position, let the heater cool down for two minutes then turn it off and pull out
the plug. There is an additional thermostat to control the fan motor. If the temperature
inside heater is high, the thermostat will also turn on the fan heater despite that the hater
is turned off. For example, after operation, when the heater is turn off, the fan motor will
still operate to cool down the temperature inside.
Note: when you switch the heater on for the first time, some smell may be released from
the heating elements: this is a normal effect that will cease in a few hours.
outlet.