Publicidad
Idiomas disponibles
Idiomas disponibles
3.
Align the groove and arrow at the
bottom of the fan housing (D) to the
arrow on the base assembly (which is
near the central hole edge of the base
assembly)
(Fig. 3).
assembly into the fan body until a
"click" is heard. Please make sure the
three buckles at the bottom of the fan
body connected closely to the base
and all connections between the fan
body and the base are tight and secure
(Fig. 4).
4.
Locate the power cord holding bracket
at the bottom of the base assembly.
Gently pull any slack out of the power
cord, place the power cord securely in
the holding bracket and secure the
power cord bracket over the power
cord. Then thread the power cord
through the U" locating notch on the
edge of the base assembly
Stand the fan in an upright position.
Note: Do not operate the tower fan unless it is
in its proper, upright position.
Push the base
"
(Fig. 5).
4
5
Publicidad
