Publicidad
Idiomas disponibles
Idiomas disponibles
Basic Operation
Connect Power
- Risk of product damage!
- Ensure that the power supply voltage
corresponds to the voltage printed on
the back or the underside of the unit.
- Before connecting the AC power
cord, ensure you have completed all
other connections.
Connect the AC power cord to the wall socket.
Power
You can use all the functions on the top of the unit or
the remote control after connecting to power supply
(called Standby Mode).
Turn On
Press
button to turn the system on from standby
mode.
When turning the system on, the system will
continue in the mode it was in when it was
turned off last time.
Turn Off
Press
button again to turn the system off and go to
standby mode.
Be sure to unplug the power cord from the outlet
when the system is not in use for an extended
period of time.
18
All manuals and user guides at all-guides.com
Set Time
The built-in clock shows the correct time in the display.
1. In standby mode, press and hold the CLOCK button
for some seconds, hour indicator will blink.
2. Set the hour with the
3. Press theCLOCK buttons to confirm, minute indicator
will blink.
4. Repeat steps 2-3 to set the minutes.
Set the Alarm Timer
You can set two alarms which go off at different time.
1. Ensure that you have set the clock correctly.
2. Press and hold ALARM1 or ALARM2.
3. Press
sound source: iPod/iPhone/iPad, FM tuner, or buzzer.
4. The display will show volume level and flash. Press
the
volume no less than Vol 8.
5. Press ALARM 1 or ALARM 2. The hour digits begin
to blink.
6. Press
7. Press ALARM 1 or ALARM 2. The minute digits begin
to blink.
8. Repeat steps 6-7 to set the minute.
Activate and Deactivate the Alarm Timer
Press ALARM 1 or ALARM 2 repeatly to activate or
deactivate the timer.
Repeat Alarm
You can press to adjust the interval to repeat alarm.
When the alarm rings, press SNOOZE/DIMMER. The
alarm repeats ringing 9 minutes later.
Stop Alarm Ring
When the alarm rings, press the corresponding ALARM
1or ALARM 2. The alarm stops but the alarm settings
remain.
View the Alarm Settings
Press ALARM 1or ALARM 2 to view the alarm settings.
Set the sleep timer
This unit can switch to standby automatically
after a set period of time.
Press SLEEP repeatedly to select a set period of time (in
minutes).
when selected the "00", then could exit the
sleep mode.
button or
/
on the remote control to select an alarm
/
buttons on the remote control to adjust the
/
repeatly to set the hour.
Dual Alarm Clock Speaker Docking iPad/iPhone/iPod
button.
Publicidad
