Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
A) Installation of ceiling connection plate
Front sticker (figure 3) on ceiling connection plate
and control panel of chimney hood should have
the same direction.
•
Drill 10mm holes from A,B,C,D points.
•
Drive 10mm wall plugs in to A,B,C,D holes.
•
Fix ceiling connection plate to ceiling by using
•
screws (5,5 x 45).Wall plugs,screws and ce-
ling connection plate are given with chimney
hood - picture 3
B) Installation of corner-pieces: Front sticker(pic-
ture 4) shows where front side of chimney hood
should be installed. Front corner-pieces should
be left and right directions. Back corner-pieces
should be extroverted. Screw 4 corner-pieces
to motor block. Hanging bar should have same
directions with ceiling connection plate. Regulat-
ing the length of chimney hood with these cor-
ner-pieces.
C) Installation of chimneys to motor
cabinet:
Please put internal chimney in exter-
nal chimney. For temporary connec-
tion between chimneys please use a
screw on motor cabinet.(So chimneys
won't drop while you install motor cab-
inet to ceiling connection plate.)Mount
the chimneys on this screw.(Screw
holes of internal chimney should befit
the side of motor cabinet.) Picture 5
All manuals and user guides at all-guides.com
Front bracket connection,
left and right up front
Back bracket con-
nection, up-front
Assembling
front surface
of body
Assembly
bracket
45
Publicidad
