Publicidad
Idiomas disponibles
Idiomas disponibles
5. CLEANING AND MAINTENANCE
Removal of oven door
1
Saddle
bracket
2
3
Cleaning of Gas Cooker - Hob Part
• Lift up the pan supports, caps and crowns of hob burners(Figure 16).
• Wipe and clean the back panel with a soapy cloth.
• Wash the caps and crowns of hob burners and rinse them. Do not leave them wet, immediately
dry them with paper cloth.
• After cleaning, make sure that you re-assemble the parts correctly.
• Do not clean any part of the hob with metal sponge. It causes the surface be scratched.
• The pan support top surfaces may be scratched in time due to usage. These parts will not get
rusted and it is not a production fault.
• During cleaning of the hob plate, make sure that no water flows inside the burner cups, as this
may block the injectors.
To remove the oven door;
• Open the oven door(1).
• Open the saddle bracket up to end position(2).
• Close the door till it almost reaches to the full
closed position as shown in 3 figure and
remove the door by pulling it towards yourself.
NOTE: To re-assemble the door follow the opposite
rules of removal.
Recessed
form
!
should be positioned properly on the hinge
counterparts as shown on 2 figure.
Please pay attention that the recessed forms
rd
nd
Publicidad
