Ryobi P105 Manual De Instrucciones página 2

BATTERY PROTECTION FEATURES
Lithium-ion battery packs are designed with features that
protect the lithium-ion cells and maximize battery life.
If the tool stops during use, release the trigger to reset and
resume operation. If the tool still does not work, the battery
needs to be recharged.
COLD WEATHER OPERATION
The lithium-ion battery pack can be used in temperatures
down to 32°F (0°C). Put the battery pack on a tool and use
the tool in a light duty application. After about a minute, the
pack will warm up and begin operating normally.
CHARGING THE BATTERY PACK
Battery packs are shipped in a low charge condition to
prevent possible problems. Therefore, you should charge
prior to first use. If the charger does not charge the battery
pack under normal circumstances, return both the battery
pack and charger to your nearest Authorized Service Center
for electrical check.
 Charge the battery pack only with the recommended
charger.
 Connect the charger to a power supply. For approved power
sources, refer to the operator's manual for the charger.
 Make sure the battery pack is secured in the charger
before beginning operation.
 Press down on the battery pack to be sure contacts on
the battery pack engage properly with contacts in the
charger.
 The battery pack may become slightly warm to the touch
while charging. This is normal and does not indicate a
problem.
 Do not place the charger and battery pack in an area of
extreme heat or cold. They will work best at normal room
temperature.
CHARGING A HOT BATTERY PACK
When using a tool continuously, the battery pack may
become hot. A hot battery pack may be placed directly onto
the charger port but charging will not begin until the battery
temperature cools to within acceptable temperature range.
When a hot battery pack is placed on the charger, the charger
may indicate the pack is not ready to charge. Please refer
to charger operator's manual. When the battery pack cools,
the charger will automatically begin charging.
CHARGING A COLD BATTERY PACK
A cold battery pack may be placed directly onto the charger
port but charging will not begin until the battery temperature
warms to within acceptable temperature range. When a
cold battery pack is placed on the charger, the charger may
indicate the pack is not ready to charge. Please refer to
charger operator's manual. When the battery pack warms,
the charger will automatically begin charging.
990000184
7-12-12 (REV:01)
SAVE THESE INSTRUCTIONS
MAINTENANCE
BATTERIES
These batteries have been designed to provide maximum
trouble-free life. However, like all batteries, they will
eventually wear out. Do not disassemble battery pack and
attempt to replace the batteries. Handling of these batteries,
especially when wearing rings and jewelry, could result in
a serious burn.
For battery pack storage longer than 30 days:
 Store the battery pack where the temperature is below
80°F and away from moisture.
 Store battery packs in a 30%-50% charged condition.
 Every six months of storage, charge the pack as normal.
BATTERY PACK REMOVAL AND PREPARATION
FOR RECYCLING
To preserve natural resources, please recycle or dispose of
batteries properly.
This product contains lithium-ion batteries.
Local, state or federal laws may prohibit
disposal of lithium-ion batteries in ordinary
trash.
Consult your local waste authority for
information regarding available recycling and/
or disposal options.
WARNING:
Upon removal, cover the battery pack's terminals with
heavy-duty adhesive tape. Do not attempt to destroy
or disassemble battery pack or remove any of its
components. Batteries must be recycled or disposed
of properly. Also, never touch both terminals with metal
objects and/or body parts as short circuit may result.
Keep away from children. Failure to comply with these
warnings could result in fire and/or serious injury.
RYOBI is a registered trademark of Ryobi Limited and is used pursuant to
a license granted by Ryobi Limited.
ONE WORLD TECHNOLOGIES, INC.
1428 Pearman Dairy Road
Anderson, SC 29625
A subsidiary of Techtronic Industries Co., Ltd.
OTC: TTNDY
Phone 1-800-525-2579
www.ryobitools.com